Updated 23 October 2026
Two batteries, two different jobs
Every hybrid and electric car has two batteries. The high-voltage pack is the large one under the floor or behind the rear seat. It drives the motor and, in a hybrid, works with the petrol engine. The second is a small low-voltage battery, usually 12 volts, of the same kind of size you would find in a compact petrol car.
The small battery runs everything the car needs before the high-voltage system is switched on: the door locks, the key or phone detection, the screens, the computers and, most importantly, the relays that connect the main pack. If the 12V battery is too weak to close those relays, the main pack stays disconnected. The car stays dark, however full the main battery is.
Once the car is on, a DC-DC converter takes power from the main pack and keeps the 12V battery charged. There is no alternator and no starter motor in the usual sense. That is why the 12V battery in a hybrid or EV has an easier daily life than one in a petrol car, but also why it can go flat quietly: the car keeps waking up its electronics while parked, and if it sits for a long time, the small battery runs down.
Why the 12V fails, especially here
- Heat. A lead-acid battery ages faster the hotter it lives, and a 12V battery in a boot or under a seat in a car parked outside in a UAE summer gets very hot.
- Long parking. Cars left in a basement while the owner travels keep drawing a small current for alarms, connectivity and app access. A Tesla in particular stays partly awake to respond to the app.
- Age. It is a wear part. Many owners never think about it until the day the car will not switch on.
- Accessories. Dash cameras wired to run while parked can drain a small battery surprisingly quickly.
The warning signs
A weak 12V battery usually gives some warning before the car goes completely dead. The wording differs by make and software version, so treat these as examples rather than exact text.
| What you see | What it usually means |
|---|---|
| Tesla: an alert along the lines of "12V battery needs service" or "low-voltage battery needs service" | The car has detected that the low-voltage battery is weak. It may keep working for a while, but plan the replacement now. |
| Toyota or Lexus: the READY light does not come on, or takes several attempts | The 12V battery cannot reliably power up the hybrid system. |
| Smart key not detected, or doors that do not respond to the key | Low voltage at the body computer. A weak 12V battery is the most common cause. |
| Dim screens, flickering lights, or a dashboard full of unrelated warnings at start-up | Electronics behaving oddly because the supply voltage dipped. |
| "Check hybrid system" or a similar warning that clears after a jump | Often a low 12V battery rather than a fault in the hybrid system itself — but have it diagnosed. |
| Car completely dead: no lights, no unlock, no response from the app | The 12V battery is flat or very nearly so. |
Any warning that names the high-voltage system and does not clear after the 12V battery is charged or replaced needs a dealer or a hybrid specialist. We work on the 12V side only and do not service main high-voltage packs.
Where the 12V battery is on common models
Carmakers move the 12V battery between generations, sometimes between model years. The table gives the usual positions on most model years. Check the owner's manual for your exact car before you start pulling trim off.
| Model | Where the 12V battery usually is | Notes |
|---|---|---|
| Toyota Camry Hybrid | In the boot on older generations; under the rear seat on most newer ones | Jump terminal in the under-bonnet fuse box on models where the battery is not under the bonnet |
| Toyota RAV4 Hybrid | Under the bonnet on most recent model years; under the boot floor on some earlier ones | Check the manual — the position changed between generations |
| Lexus RX hybrid | Under the bonnet on most model years | Usually a straightforward position, but some trims add covers to remove |
| Lexus ES hybrid | In the boot or under the rear seat, depending on generation | Under-bonnet jump terminal on most model years |
| Tesla Model 3 and Model Y | At the front of the car, behind a panel under the front trunk (frunk) area | Newer cars use a lithium-ion low-voltage battery instead of lead-acid; see below |
| Tesla Model S and Model X | At the front of the car, under panels in the frunk area | Recent versions also use a lithium-ion low-voltage battery |
For more detail by brand, see the Toyota page and the Tesla page in our make index.
Lead-acid or lithium-ion: what newer Teslas use
Older Teslas use a conventional 12V lead-acid battery. Tesla has since moved its cars to a lithium-ion low-voltage battery, which lasts much longer and is designed to be replaced far less often. Which one your car has depends on the model and when it was built, and Tesla has not switched every model at the same time. The service screen in the car or Tesla's own documentation will confirm which type is fitted.
This matters because the two are not interchangeable. A car built for the lithium-ion low-voltage battery should get the same type back, and the lead-acid replacement for an older car must match the original specification. If you are not sure which you have, tell us the model and year when you call and we will check before anyone sets off.
Getting into a Tesla with a dead 12V battery
With the 12V battery flat, a Tesla will not respond to the phone key, the key card or the app, and the door handles will not present. You cannot simply open the bonnet either, because the frunk release is electric.
Tesla's owner's manuals describe a way to power the front trunk release from an external 12V supply on Model 3 and Model Y, through two wires reached from behind the front tow-eye cover. Once the frunk is open, the 12V battery area can be reached and the car can be woken up. The exact steps differ between models and years, so follow the manual for your car precisely, and do not connect anything if you are unsure of polarity.
If you are already inside the car when it goes dead, the front doors have a mechanical release. Check the manual for its location before you need it — it is not obvious the first time.
Why jump-starting a hybrid only goes one way
A hybrid or EV with a flat 12V battery can be jump-started from another car, a jump pack or a booster. The jump does not crank an engine. It only gives the electronics enough voltage to close the relays and switch the high-voltage system on. Use the jump terminal named in the owner's manual, which on many Toyota and Lexus hybrids is in the under-bonnet fuse box. Our jump-start guide gives the full cable order.
The reverse is the problem. Most hybrid and EV manuals advise against using the car as a donor to start a petrol or diesel car. A conventional starter motor can draw far more current than the hybrid's 12V circuit and DC-DC converter are built to supply, and the damage is not cheap. Tesla's guidance is that its cars should not be used to jump another vehicle.
A jump only gets the car going. If the 12V battery went flat without an obvious reason, such as weeks of parking, it is likely to do so again. Have it tested.
What replacing the 12V involves
On most models it is a short job: the right battery for the car, any trim or covers removed, the battery fitted, and the car checked afterwards. Some cars log fault codes when the 12V drops, and those should be cleared once the new battery is in. It is also worth confirming the DC-DC converter is actually charging the new battery, so a charging fault is not mistaken for a bad battery.
Our hybrid and EV 12V battery service in Dubai Creek Harbour covers Toyota and Lexus hybrids, Tesla and other EVs, including cars parked in basement charging bays. It covers the 12V battery only, never the main pack. If the 12V battery tests fine, the diagnosis costs nothing.


