Skip to content
Creek HarbourBattery Service

Guide · Jump starting

How to jump start a modern car safely

Most jump-start instructions were written for cars from the 1990s. On a car with a battery sensor, a boot-mounted battery or stop-start, the order is the same but the connection points are not.

16K+

Trusted by 16,000+ Customers

4.9
Pay with tamaraPay with tabby

Split it into 4 payments

0% interest · No hidden fees

Arrival
~20 min
Warranty
24 months
Makes
All of them
Open
24/7

Updated 23 October 2026

Before you connect anything

Check three things first. The battery case must not be swollen, cracked or leaking — if it is, do not jump it, because a damaged lead-acid battery can vent flammable gas. Both cars must be switched off with the keys away from the ignition. And the two batteries must be the same voltage: every ordinary car is 12 volts, but some trucks and heavy plant run 24 volts.

Then find the jump points on the flat car. On many modern cars these are NOT the battery terminals. Open the bonnet and look for a red cap marked + and a bare bolt or stud marked with an earth symbol or the word GND. If the car has them, use them, even if you can see the battery.

The cable order

  1. Red clamp on the positive (+) jump point of the flat car.
  2. Other red clamp on the positive (+) terminal of the donor car.
  3. Black clamp on the negative (−) terminal of the donor car.
  4. Last black clamp on the earth point of the flat car — the marked earth stud or a bare, unpainted bracket on the engine, away from the battery.

Start the donor car and let it run for two or three minutes before you try the flat one. That puts some charge into the flat battery rather than asking the donor to do all the work through the cables. Then try to start the flat car. Crank for no more than about ten seconds at a time and wait a minute between attempts so the starter motor and cables do not overheat.

Once it is running, remove the clamps in the reverse order: black from the earth point, black from the donor, red from the donor, red from the flat car. Keep the clamps from touching each other or any metal while they are live.

Why the last clamp goes on an earth point, not the battery

Two reasons. The old one: a battery being charged can give off hydrogen, and the final connection can spark, so you make it away from the battery. The modern one: many European and premium cars clamp an intelligent battery sensor onto the negative battery terminal. It measures every amp that goes in and out so the engine computer can manage charging. Clamp the black lead straight onto that terminal and the jump current bypasses or passes through the sensor — at best the car's charge picture is wrong afterwards, at worst the sensor is damaged.

If you cannot find a marked earth point, a bare metal engine bracket works. A painted body panel does not conduct well, and nothing near the fuel system is acceptable.

Jump points when the battery is in the boot or under a seat

Carmakers that move the battery out of the engine bay almost always put jump points under the bonnet so nobody has to empty the boot at the roadside. The table below shows the usual arrangement. Layouts change between generations, so treat it as a starting point and check the owner's manual for your exact car.

MakeWhere the battery usually isWhere to connect
BMWBoot floor on most modelsPositive jump post under a red cap in the engine bay; marked earth stud beside it
Mercedes-BenzEngine bay, boot, or under the front passenger floor, depending on modelMarked positive terminal in the engine bay; earth stud nearby
Range Rover / Land RoverUnder a floor or boot panel on many models; some have a second, auxiliary batteryPositive jump terminal in the engine bay, often under a cover by the fuse box
Tesla (12V / low-voltage)Behind a panel at the front of the carThe 12V only wakes the car — follow Tesla's procedure in the manual, and never use a Tesla to jump another car
Toyota and Lexus hybridsUnder the bonnet, in the boot or under the rear seat, depending on modelJump terminal in the under-bonnet fuse box on models with the battery elsewhere

On cars with a boot-mounted battery the boot can also be impossible to open with the battery flat. That is another reason the engine-bay jump points exist. You can read more about where batteries live by make on our car makes index, for example the BMW page or the Land Rover page.

Hybrids, stop-start and EVs

A hybrid's 12V battery can be jumped from another car to get the system to switch on — it does not crank an engine, it only powers up the electronics that start the hybrid system. Most hybrid manuals warn against using the hybrid as the donor for an ordinary car, because a petrol car's starter can draw more current than the hybrid's 12V circuit is built for. The same caution applies to EVs.

Stop-start cars run AGM or EFB batteries. They can be jumped normally through the jump points. What matters is afterwards: the battery management system may keep stop-start switched off until the battery has recovered, and a deeply flattened AGM battery often does not recover fully. See our hybrid and Tesla 12V guide for more on the 12V side.

Never do these

  • Never jump a battery that is swollen, cracked, leaking or smells of rotten eggs.
  • Never bump-start or tow-start an automatic — it does not work and can damage the gearbox.
  • Never clamp onto a battery sensor or a boot-mounted negative post.
  • Never let the clamps touch each other once any of them is connected.
  • Never connect a 24V vehicle to a 12V car.

After the car starts

Drive for at least thirty minutes on a steady road, not a series of short hops, or put the battery on a proper charger. Short trips from Dubai Creek Harbour to Downtown are rarely enough to replace what the start took. Then get the battery tested. A jump start tells you the battery was flat; it does not tell you why.

If a car needs jumping twice in the same week, the battery has either lost capacity or something is draining it while parked. A load test and a parasitic-drain measurement answer that in a few minutes — see battery and charging-system testing.

When there is no donor car

In a tower basement there is often no second car beside yours, and parking another car nose-to-nose in a numbered bay is not always possible. A portable jump pack is one answer — our jump pack guide covers what works in UAE heat. The other is to have someone come to you with a booster and a tester: our jump start service in Dubai Creek Harbour boosts the car at the correct points and load-tests the battery afterwards.

Questions

Quick answers

What drivers ask before booking.

Still unsure? Call +971 54 319 7500 — a technician answers, not a call centre.

Which lead goes on first when jump starting a car, red or black?

Red first. Red on the flat car's positive, red on the donor's positive, black on the donor's negative, then black on an earth point on the flat car. Remove them in the reverse order.

How long should I wait before starting the flat car?

Let the donor run for two or three minutes with the cables connected, then try. Crank for no more than about ten seconds at a time, with a minute's rest between attempts.

Can jump starting damage a modern car?

It can if the negative clamp goes straight onto a battery fitted with an intelligent battery sensor, if the clamps touch, or if the polarity is reversed. Using the engine-bay jump points in the right order avoids all three.

How long should I drive after a jump start?

At least thirty minutes of steady driving, or put the battery on a charger. Then have it tested, because a battery that went flat once without an obvious reason often does it again.

Ready when you are

A car that will not start is a thirty-minute problem.

Call or WhatsApp with the make, the model and where the car is parked. We will quote the fitted price before anyone sets off.

24/7, every day · Every tower in Dubai Creek Harbour · All makes

Call · 20 minWhatsApp